Case : The head carriage swings slowly, causing low-speed printing
Reforming the continuous ink supply system will often renovate the original ink cartridges, which will inevitably lead to the burden on the car. Under overloaded conditions, the word carriage will act slowly. Moreover, overloading can also lead to accelerated aging of the printer belt and increase the friction between the carriage and the connecting rod. These will cause the print speed to slow down. In severe cases, it can also cause the car to fail to reset and then become unusable.
Failure reasons and solutions: 1, replace the motor. The hose of the continuous ink supply system is rubbed against the wall of the printer, resulting in an increase in the load on the electric motor, long-term loss of the electric motor, and attempt to replace it; 2. Lubrication of the connecting rod. For a long time, the friction between the carriage and the connecting rod in the machine becomes large, and the increase in resistance causes the electric motor to run slowly. At this time, lubrication of the connecting rod can solve the problem; 3, the printer belt is aging. The gear friction force connected with the motor will accelerate the aging of the belt of the printer. At this time, cleaning and lubrication can reduce the aging of the belt.
Editor’s Note: This post was Published by Proffisy on 27 Jun,2018.